Page 90
2017-01-13
Release: 02.0
6.6.6 Output commands
All fieldbus outputs can be freely defined via the "aflexConfigurator", both in the data
range as well as in the data position. The suggested range of data listed in the table
below indicates the original data range of the command. These are recommended for
e.g. to stick with for 1-bit wide commands, however, all commands can be stretched or
compressed to any data range. The target module tells from which module of the aflex
control the status is generated.
Table 13: Output commands
Target
module
Designation:
Description
Native
data
range
Control
Unit:
AutoMode:
Status Automatic/Manual Mode.
1 Bit
Control
Unit:
General Release
Status of release
1 Bit
Control
Unit:
Load Config
Number
Current loaded configuration
8 Bit
Control
Unit:
Load Config
Number #1
Status if configuration 1 is loaded
1 Bit
Control
Unit:
Load Config
Number #2
Status if configuration 2 is loaded
1 Bit
Control
Unit:
Load Config
Number #3
Status if configuration 3 is loaded
1 Bit
Control
Unit:
Load Config
Number #4
Status if configuration 4 is loaded
1 Bit
Control
Unit:
Load Config
Number #5
Status if configuration 5 is loaded
1 Bit
Control
Unit:
Aux Power Out-
put
Status of the control intensity on 24V
output of the control unit
16 Bit
aflex-Mod-
ule
Intensity
Status of the control intensity of aflex
32 Bit
aflex-Mod-
ule
Frequency
Status of the oscillation frequency of
aflex
Caution: minimum 16 bit necessary
32 Bit
aflex-Mod-
ule
Direction
Status of the direction of movement of
aflex
32 Bit
T4X Driver
Channel1 Power
Status of the control intensity of driver
output
32 Bit
