84
Operation Steps
1.
Press
Trigger Setup
to enter the
TRIGGER
function menu.
2.
Press the
Type
F keyand select
Serial
.
3.
Press the
Protocol
F key and select
I2C
.
4.
Press the
Trigger Setting
F key.
Figure 40 I2C TRIGGER Menu
5.
Press the
Condition
F key and turn the
Universal Knob
to select the trigger condition:
l
If you select the
EEPROM
condition:
a.
Press
the
Limit Range
F key to set the qualifier (=, < or
>
).
b.
Press the
Data1
F key and set its value by turning the
Universal Knob
.
l
If you select
7 Addr & Data
or
10 Addr & Data
condition:
a.
Press the
Addr
F key and turn the
Universal Knob
to select the 7- bit or 10- bit device
address.
b.
Press the
Data1
or
Data2
F key and set their value(s).
c.
Press the
R/W bit
F key and select write-frame or read-frame to trigger the oscilloscope.
(
Tips
: If device address is 7-bit, the value of address is in range of 0x00 to 0x7F. If device’s
address is 10-bit, the value of address is in range of 0x00 to 0x3FF.)
l
If you select the
Data Length
condition:
a.
Press the
Address
to set the SDA address length 7bit or 10 bit.
b.
Press the
Byte Length
F key and set the byte length by
Universal Knob
. The range of
the Byte Length
is 1 to 12.
Summary of Contents for OSC-9200
