126
Type of Measurement
Voltage Measurements
Voltage measurements include 17 parameter measurements.
Figure 78 Voltage Measurements
1.
Peak-Peak:
Difference between maximum and minimum data values.
2.
Maximum:
Highest value in input waveform.
3.
Minimum:
Lowest value in input waveform.
4.
Amplitude:
Difference between top and base in a bimodal signal, or between max and min in
a unimodal signal.
5.
Top:
Value of most probable upper state in a bimodal waveform.
6.
Base:
Value of most probable lower state in a bimodal waveform.
7.
Mean:
Average of all data values
8.
Cycle mean:
Average of data values in the first cycle.
9.
Stdev:
Standard deviation of all data values
10.
Cycle Stdev:
Standard deviation of all data values in the first cycle
11.
Rms:
Root mean square of all measured values.
12.
Cycle RMS:
Root mean square of all data values in the first cycle.
13.
Overshoot:
Overshoot is distortion that follows a major edge transition expressed as a
percentage of Amplitude. ROV means rising edge overshoot and FOV means falling edge
overshoot.
Summary of Contents for OSC-9200
