180
Measure Logger
The Measure Logger can record the measured values of waveforms in real time to allow long term
measurement of low-speed signal. The measurement data is recorded in internal memory, and can be
saved to internal storage or a USB drive after stopping recording. The Measure Logger can record up
to four measurements at once.
To use the measure logger, first press
Measure
to turn on the measure function (while in Scope mode),
and select up to four measurements to display. Then press
Recorder
→
Measure Logger
to turn on
the measure logger. When finished, press the
Exit
F key to exit the measure logger.
Figure 115 Measure Logger Interface
No.
Description
1
Measurement trace
2
Record status
（
Run/Stop
）
3
[Auto/Manual] Horizontal scale
4
[Auto/Manual] Time value of the first point (centered on horizontal reference position)
5
Horizontal reference position
6
Remaining recordable time, Recording interval, Number of recorded points
Summary of Contents for OSC-9200
