156
Keyboard Test
The keyboard test is used to verify that the keys and knobs work properly.
1.
Press
Utility
on the front panel to enter the UTILITY function menu.
2.
Press the
Next Page
F key to go to the third page of the UTILITY function menu.
3.
Press the
Do Self Test
F key to enter the SELFTEST function menu.
4.
Press the
Keyboard Test
F key to enter the keyboard test interface, as the picture shown below.
Figure 96 Keyboard Test
To perform the knobs and the buttons test:
5.
Knobs test: the default value is 0. Turn the knob left to increase the value, and right to decrease;
push the knob to set the value to 0.
6.
Keys test: The first time you press a key, it will light up, and pressing it again will turn it off. Test
every button randomly to ensure they all light up and turn off.
7.
Press
Run/Stop
3 times to exit the keyboard test program.
Summary of Contents for OSC-9200
