24
Adjusting the Scale
The vertical scale can be adjusted in
Coarse
or
Fine
mode.
l
Coarse
adjustment (take counterclockwise as an example): set the vertical scale in 1-2-5 step
namely 2 mV/div, 5 mV/div, 10 mV/div …10 V/div.
Fine
adjustment: further adjust the vertical scale within a relatively smaller range to improve
vertical resolution. For example: 2 V/div, 1.98V/div, 1.96V/div, 1.94 V/div …1 V/div.
l
If the amplitude of the input waveform is too large at the current scale, but would be too small if
the next scale up was used, fine adjustment can be used to improve the amplitude.
Press
CH1
on the front panel, then press the
Adjust
F key to choose the desired mode. Press
Vertical
Scale
to adjust the vertical scale (
V
to increase the scale and
mV
to reduce).
The scale information in the channel information bar at the bottom of the screen will change during
the adjustment process. The adjustable range of the vertical scale is related to the probe attenuation
ratio. By default, the probe attenuation factor is 1:1 (1X) and the adjustable range of the vertical scale
is from 2 mV/div to 100 V/div.
Summary of Contents for OSC-9200
