60
Note
: Press the Auto Setup button will set the trigger type to Edge and slope
to rising.
Edge Trigger
Edge triggering distinguishes the trigger points by seeking the specified edge (rising, falling,
alternating) and trigger level.
1.
Press
Trigger Setup
on the front panel to enter the TRIGGER system function menu.
2.
Press the
Type
F key; turn the
Universal Knob
to set select
Edge
and then push the knob to
confirm.
3.
Press the
Source
F key; turn the
Universal Knob
to select the desired trigger source.
4.
Press the
Slope
F key; turn the
Universal Knob
to select the desired trigger edge (rising, falling
or alternating), and then press down the knob to confirm. The current trigger slope is displayed
at the bottom of the screen.
5.
Press the
Trigger Level
button and turn the
Universal Knob
to adjust the trigger level to obtain
a stable trigger.
Figure 27 Edge Trigger
Holdoff, coupling, and noise rejection can be set in edge trigger mode. See the sections “Trigger
Holdoff,” "Trigger Coupling," and "Noise Rejection" for details.
Summary of Contents for OSC-9200
