R3765/67G Series Network Analyzer Operation Manual
8.2 Error Messages
8-2
8.2
Error Messages
This chapter explains the error messages displayed on the screen.
(1)
Types of error message
Hardware trouble
(Refer to sub-section 8.2.1.)
Notice of hardware information
(Refer to sub-section 8.2.2.)
Operating error
(Refer to sub-section 8.2.3.)
Warning of the change of internal setting and the like
(Refer to sub-section 8.2.4.)
Notice of the completion of an operation, the operating state and the like
(Refer to sub-section 8.2.5.)
(2)
Error message display
•
The message is displayed on the fixed position of the liquid crystal display. Therefore
the message is overwritten and only the last message is displayed.
•
The message does not disappear until some panel key is pressed. However, the
messages in
and
disappear when the R3765/67G series is returned from the
state.
•
The messages of
,
and
are not displayed during GPIB command operation
(including BASIC).
(3)
Error message, the cause and the solving method
Explains in the following error message table.
8.2.1
Hardware Trouble
Cooling Fan Stop.
Please Power OFF.
Source Unlevel
Synthe Unlock
Cooling fan stopped.
Please power OFF.
The signal source is at low level.
The internal reference frequency source is out of the phase-locked
loop.
<How to handle>
Contact a sales representative
1
2
3
4
5
1
2
4
5
6
