ADTRAN Atlas 800 Plus, User Manual

Page: 46 / 210

Chapter 3. Operating the ATLAS 800PLUS
3-4 ATLAS 800
PLUS
User Manual 61200226L1-1
Starting a Telnet Session
When you begin the Telnet session, you will be prompted for a password.
The default password is
password
(which is a Level 0 superuser password).
You can change this password using the
Access Passwords
option, which
is only accessible through the terminal menus. See Access Passwords on page
6-11 for details. The Telnet session will time out and display the Login
prompt after a pre-defined time that is set in the
Session Timeout
option
(see Session Timeout on page 6-8 for details).
Using VT-100 Terminal Emulation
An EIA-232 serial connection is available via the Chain In port on the rear
panel of the ATLAS 800
PLUS
. The ATLAS 800
PLUS
provides the Front Panel
menus to a VT-100 type terminal. The following Step/Action table provides
instructions for setting up the ATLAS 800
PLUS
for VT-100 terminal mode.
Instructions for Setting the Gateway IP Address
Step Action
1
From the Front Panel, select 2) CONFIG , then S0) SYSTEM , then
1) ETHERNET .
2
When the submenu displays, select
3) DEF GATEWAY
.
3
Enter the default gateway by entering each number followed by
Enter to move to the next field.
4
Press
Enter
after keying in the entire address.
You will need a default gateway if the LAN contains multiple
segments. Contact your LAN administrator for the appropriate
address.
Use the
Max Telnet Sessions
option to define the number of
Telnet sessions that can be active at one time (see Max Telnet
Sessions on page 6-8 for details).
Microsoft Telnet version 1.0 does not implement full VT-100
emulation. However, many commercial Telnet clients for Microsoft
Windows exist which fully implement VT-100. In addition, a
freeware client which is recommended for optimum performance is
delivered with the ATLAS 800
PLUS
. See VT-100 Utility on page
13-8 for details.