ADTRAN Atlas 800 Plus, User Manual

Page: 127 / 210

Chapter 10. Dial Plan Terminal Menu
61200226L1-1 ATLAS 800
PLUS
User Manual 10-15
versus data calls. A setting of
Normal
indicates no special facilities have
been subscribed.
»» Called Digits
Transferred
Write security: 3; Read security: 5
Defines to ATLAS the number of called-number digits to forward. When
attached to a PBX, the PBX may be provisioned to expect to receive fewer
than all of the called digits of the incoming call. This would normally be set
to
All
.
»» Outgoing Caller ID
Write Security: 3 Read Security: 5
This item allows the user to insert a called ID to be added to outgoing calls
(coming in from attached User equipment). If set to
Send as Provided
, then
ATLAS will forward whatever ID it receives (including none). If set to
Sub-
stitute if not present
, then ATLAS will insert a User defined ID value if no
value is received. If set to
Substitute Always
, then ATLAS will always insert
the User defined ID in place of the value received.
» ID Presentation
Defines control information for the presentation of Caller ID to be inserted
(
Presentation Allowed; Presentation Restricted; Number Not Available
).
» ID Number
Value for Caller ID to be sent to the Network (i.e., 256 963 8020).
» Source ID
The Source ID field simplifies the creation of a Dial Plan in applications
where the criterion for switching calls to a certain end point is a function of
which end point originated the call.
• Default value = 0. The default ID for all end points is 0 and all accept # s
is 0. With default values, all calls are routed based only on dialed num-
ber.
• Multiple end points can have the same
Source ID
.
• When creating the Call Accept list, specify a Source ID (s) as well as a di-
aled number or range of dialed numbers to accept.
For example, an application requires that all calls originating from Port 1 of
the Quad T1/PRI module in Slot 1 be switched to Port 4 of that same mod-
ule. Assign a unique
Source ID
(e.g., 7) to Port 1 of the module, and then
configure Port 4 to only accept calls from that unique
Source ID
(7).
»» Swap ANI/DNIS
This option swaps the ANI and DNIS numbers prior to being forwarded to
the attached user equipment. ANI (Automatic Number Identification) is
the billing number of the calling party, and DNIS (Dialed Number Identifi-
cation Service) is the called party number.
This swap will occur after the ATLAS switchboard has routed the
call. The accept # in the dial plan must use the number in the DNIS
position prior to swapping.