ADTRAN Atlas 800 Plus, User Manual

Page: 102 / 210

Chapter 8. Dedicated Maps Terminal Menu
8-8 ATLAS 800
PLUS
User Manual 61200226L1-1
Figure 8-4. Slot 0 Module Configuration Menu
Defining the Connections
Begin by navigating to
Dedicated Maps / Create/Edit Maps
and naming
your map.
Navigate to
Dedicated Maps / Connects
. The
Connects
submenu defines
the connections necessary to route the required bandwidth. Refer to Table 8-
1 to define each of the necessary connections. For this procedure, first define
the data connections, and then define the voice connections. The following
Step/Action tables guide you through this process. (Figure 8-5 shows the
completed map.)
Instructions for Defining Data Connections
Step Action
1
For Data A, select and define FROM Slot ( i.e. ,
0 Sys Ctrl
).
2 Select and define "from" Port (i.e., port 1 for T1: Data A).
3
Select and define
From Config
DS0s (i.e.,
DS0=9-24).
4
Select and define TO Slot and "to" Port in the same way (i.e.,
2 V.35Nx4 and 1 where 2 = Slot 2 and 1 = Port 1.)
5
From To Config, set V.35 to operate at 56k/64k per DS0.
6
Repeat for the remaining data connections (i.e., Data B and
Data C) as follows:
6a
Insert new connection lines by positioning the cursor over the
index # of the first connection and pressing
I .
6b
Copy the first connection by positioning the cursor on the index #
and pressing
C
.