ADTRAN Atlas 800 Plus, User Manual

Page: 56 / 210

Chapter 4. Using the Front Panel
4-8 ATLAS 800
PLUS
User Manual 61200226L1-1
»» Ethernet Allows you to create and change configuration settings for the 10BaseT
Ethernet connection.
»» Chain Port The Chain Port configuration menu option modifies selected items in its
menu branch.
IP Address
Uniquely identifies the ATLAS 800
PLUS
on a TCP/IP
network. This address is composed of four decimal num-
bers, each in the range of 0 to 255, separated by periods.
This value is set to 0.0.0.0 by default. The IP address is
used for the 10BaseT Ethernet interface. Obtain the cor-
rect IP address from your LAN administrator. Enter the
IP address by entering each number followed by
Enter
to move to the next field.
You must define the IP address before attempting to use a
Telnet program.
Subnet Mask Defines which part of a destination IP address is the
Network number. This address is composed of four dec-
imal numbers, each in the range of 0 to 255, separated
by periods. This option is used along with the
ATLAS 800
PLUS
IP address to determine which nodes
must be reached through the default IP gateway. Enter
the subnet mask address by entering each number fol-
lowed by
Enter to move to the next field.
Def Gateway
Allows you to define or change the default gateway. You
will need a default gateway if the LAN contains multi-
ple segments. This address is composed of four decimal
numbers, each in the range of 0 to 255, separated by
periods. This value is set to 0.0.0.0 by default. Contact
your LAN administrator for the appropriate address.
Enter the default gateway address by entering each
number followed by
Enter to move to the next field.
Baud Rate Displays and changes the baud rate. The supported
baud rates for the chain port include 2400 and 9600 bps.
If
Type is set to Dial , make sure this field matches the
modem baud rate.
Flow Ctl
Sets the flow control for the chain port. You can config-
ure the chain port flow control for
OFF or H/W (hard-
ware).
Type Sets the Port Type to either Direct or Dial . Select Direct
to connect to a local VT 100 and select Dial to connect via
a modem.