ADTRAN Atlas 800 Plus, User Manual

Page: 196 / 210

Index
Index-2 ATLAS 800
PLUS
User Manual 61200226L1-1
FR 9-5, 9-6
primary 9-6
backup timing source 6-7
bantam test jack 2-3
baud rt 4-8
begin firmware update 6-15
BES 7-5
blinking green module status LED 4-3
blinking green system LED 4-3
blinking red module status LED 4-3
blinking red system LED 4-3
blue alarm 7-4
BONDING Config 6-12
bonding configuration 6-12
boot ROM rev 6-3
bootROM 6-18
bursty errored seconds 7-5
C
Call Stagger 6-13
call stagger values 6-13
call type 10-18
called digits transferred 10-10, 10-15
caller ID number 10-17
cancel 4-1, 4-4
menu 4-5
capture 13-7, 13-9
category 6-4
logging A-1
chain in 2-4
pinout 2-5
chain out 2-3, 2-5
pinout 2-5
chain port
configure 6-8
framing errs 6-7
overrun errs 6-7
Rx bytes 6-7
signal leads 6-6
status menu 4-7
Tx bytes 6-7
chain port configuration 4-8
chain-in port 2-3
chain-out port 2-3
challenge # 4-11
circuit status 6-1
backup status 9-6
delay 9-6
from 9-5
line status 9-6
man 9-5
test 9-7
Circuit Status Menu 9-5
circuit status menu 9-5
clear
performance data 7-5
selftest log 6-18
system event log 6-4
system LED 6-5
test pattern 7-7
clear history 4-12
clear key 4-1, 4-4
clear log 13-11
clearing fields 4-2
clock 6-10
CLR 7-5
code 7-6
colors 13-7, 13-9
community
trap destination 6-10
completed network map 10-27
completed user map 10-28
config 4-7
config menu
ethernet configuration 4-8
S0 system 4-7
S1-S8 4-9
config transfer 6-16
configuration
from port 8-3
get from TFTP server 13-13
interface 10-7
load 6-17
module 7-5
Quad T1/PRI interface 10-9
save to server 6-17
save to TFTP server 13-12
use 6-17
configuration file
get from server 6-16
send to server 6-16
configuration menu 4-7
configure 6-8
chain port 6-8
configure
port type 6-9
default gateway 6-8
ethernet port 6-8
ethernet port name 6-8
event logging 6-10
flow control 6-9
IP address 6-8
module slots 7-2
subnet mask 6-8
configuring ATLAS 800 PLUS 6-1
configuring Syslog 6-10
connect
Telnet menu 13-6