Additel 226, User Manual

Page: 48 / 107

36
HART measurement channel screen when the HART device is not connected to enter the HART power supply
configuration interface. The configuration provided by the calibrator is as Figure 10, 11 and 12.
After selecting the configuration, go to the search interface. Start searching for HART devices from address "0", if the
search is success, it will stop searching and display the HART device list and main information, otherwise the calibrator
will start searching from address "1" until address "15", After completing the search, the calibrator will list all the searched
HART devices, and can display up to 15 HART devices at the same time.
3.4.2 HART Setting
In the Calibrator page, switch to HART gear and click icon to go to the settings, including device information,
sensor information and device output, see Table 13.
Table 13 HART settings
Subject Parameter Description and valid value
Device
information
Label Support letter, symbol and number, the length cannot be greater than 8 characters
Date Any date supported by transmitter
Information Support letter, symbol and number, the length cannot be greater than 32 characters
Description Support letter, symbol and number, the length cannot be greater than 16 characters
Final Assembly Number Support integer, the length cannot be greater than 8 characters
Preambles Integer 5~20
Manufacturer Read only
Device type Read only
Device ID Read only