User's Manual | ACOM eBox | Ethernet Remote Control Device
Page 48 of 60 | S e c t i o n MAINTENANCE
October 2021
7.
MAINTENANCE
7.1.
Periodic Maintenance
Periodically (but at least once per year) check all connections, contact cleanliness and the tightening of all
connectors, in particular Ethernet ones.
Check the integrity of the cables, in particular when they are laid on the floor. Check also if the cables are
secured well in the area where they come out of the connector body.
7.2.
Cleaning
CAUTION
Do not use any solvents for cleaning. They may be dangerous to you and damage eBox
surfaces, paint and plastic components.
Do not open the eBox. Cleaning of the device outer surface can be done with a piece of soft cotton cloth
lightly moistened with clean water.
7.3.
Reset to Factory Default Settings
If you have any troubles with eBox device, first you can try to reset device to clear the problem.
Reset to Factory Default Settings procedure:
•
Make sure that the device is powered OFF (
PWR
LED is OFF, the power supply cable is
disconnected);
•
Press and hold the
RESET
button (see
Figure 2-5 Rear panel - Connections
•
While still pressing the button, power ON the device (connect power supply cable to eBox);
After 5-7 seconds, the LEDs on the front panel of eBox will start blinking simultaneously,
indicating that the procedure has completed;
•
Release the
RESET
button. The eBox is ready for use.
NOTICE
Do not interrupt the Reset to Factory Default Settings procedure. If you interrupt
procedure, it may result in inoperative device (not covered under warranty).