Acom eBox, User Manual, Page: 16 / 60

User's Manual | ACOM eBox | Ethernet Remote Control Device
Page 16 of 60 | S e c t i o n INSTALLATION October 2021
If you have an ACOM 600S, 700S, or 1200S amplifier, please, see
Figure 2-6 eBox to ACOM 600S, 700S, or
1200S connection
and
Table 2-1 eBox to ACOM 600S, 700S, and 1200S connection cable wiring
for correct
connection cable wiring.
It is necessary to use the original connection cable (delivered with an eBox) and connect the
AMPLIFIER
connector (on eBox rear panel, see Pos. (1) below) to the amplifier RS-232 connector (on amplifier rear
panel, see Pos. (2) below).
In this case, the
RCU connector (on eBox rear panel, see Pos. (3) below) remains unused.
Figure 2-6 eBox to ACOM 600S, 700S, or 1200S connection
Figure 2-6 eBox to ACOM 600S, 700S, or 1200S connection
Table 2-1 eBox to ACOM 600S, 700S, and 1200S connection cable wiring
eBox
Rear panel
Connecting cable
ACOM
600S, 700S, and 1200S
Rear panel
AMPLIFIER
connector
RS-232
connector
D-sub
connector,
15-pin,
3-row,
male
1 | GND
D-sub
connector,
15-pin,
3-row,
female
1
Not connected
-
D-sub
connector,
9-pin,
male
1 | Not connected
D-sub
connector,
9-pin,
female
2 | Pin2_A 2
Not connected
- 2 | TxD
3 | Pin3_A 3
Not connected
- 3 | RxD
4 | +10AMP 4
Not connected
- 4 | Not connected
5 | CPU_ON_A# 5 Blue 6 5 | GND
6 | RX_485_TX_P 6
Not connected
- 6 | DSR
7 | CPU_RST_A# 7
Not connected
- 7 | Not connected
8 | RCU_CPU_A 8
Not connected
- 8 | CTS
9 | CPU_RCU_A 9
Not connected
- 9 | Not connected
10 | GND 10 Black 5 Housing
11 | RS_485_TX_N 11
Not connected
-
12 | RS_485_RX_P 12
Not connected
-
13 | RS_485_RX_N 13
Not connected
-
14 | RS_232_TX 14 Red 3
15 | RS_232_RX 15 Yellow 2
Housing Housing Ext. shield Housing
Table 2-1 eBox to ACOM 600S, 700S, and 1200S connection cable wiring
1
2
3