User's Manual | ACOM eBox | Ethernet Remote Control Device
October 2021
S e c t i o n DEVICE AND AMPLIFIER SETTINGS | Page 35 of 60
b)
PA Settings
panel
Please, see
Figure 5-5 eBox with ACOM 2000A connected
, Pos. (b).
Changes to this panel can be made only while the amplifier is switched OFF.
Panel functional buttons:
•
Clear User Tunings
Clears the tunings done by the user;
•
Revert
When it is pressed the change in the panel will go back to the last saved value;
•
Save
When it is pressed the changes in a panel are saved.
Panel functional fields:
•
Auto Operate
Enable/Disable Auto Operate feature. When Auto Operate is enabled the amplifier will
automatically revert to OPERATE mode after a soft-fault protection trip;
•
RCU Local Control
Enable/Disable local control of the amplifier from its own RCU;
•
Auto Ant. Change
Automatically select an antenna, corresponding to the measured frequency of the drive
signal. Requires an antenna to be set for the corresponding band (see Section
);
•
Self Address
When ACOM 2000A amplifier is part of serial network chain, you can assign amplifiers self-
address here. When the amplifier is not used in serial network chain, this address is
meaningless.
c)
Antenna Alias
panel
Please, see
Figure 5-5 eBox with ACOM 2000A connected
, Pos. (c).
Panel functional buttons:
•
Revert
When it is pressed the change in the panel will go back to the last saved value;
•
Save
When it is pressed the changes in a panel are saved.
Panel functional fields:
•
Antenna 1, 2, … 10
Assign names of the used antennas (max. 10 antennas). This feature is used when working
together with an automatic antenna selector ACOM 2000S and remote antenna switch ACOM
2000SW.