33
1
Check first to make sure you have not left loose tools or parts
inside the system.
2
Check that cables, add-in boards, and other components are
properly installed.
3
Attach the panels to the chassis with the screws removed earlier,
and tighten them firmly.
4
Insert and lock the padlock to the system to prevent unauthorized
access inside the system.
5
Connect all external cables and the AC power cord(s) to the
system.
Hardware setup
The server is shipped without processors, memory, or hard drives. To
install the memory, processors, hard drives, and other options, follow
the steps shown below.
1
Removing the system access panels:
a
Removing the rear access panel - see page 44
b
Removing the access cover to the system boards - see page 51
2
Removing the memory and processor boards:
a
Removing the memory board - see page 52
b
Removing the air baffle - see page 54
c
Removing the processor board - see page 55
3
Installing memory and processors:
a
Installing the DIMMs on the memory board - see page 62
b
Installing the processors on the processor board - see page 66
4
If you are installing an ICMB board - follow the instructions that
came with the ICMB board kit.
5
Installing the processor and memory boards:
a
Installing the processor board - see page 56
b
Installing the air baffle - see page 54
c
Installing the memory board - see page 53
6
Installing PCI add-in cards - see page 69
7
Installing hard disk drives - see page 80
AA G900 ug - EN.book Page 33 Wednesday, September 25, 2002 5:23 PM
Summary of Contents for Altos G900
