187
Using a specified CFG file
In most cases, you'll use the standard configuration file master.cfg that
is supplied with the utility on the System CD and with software
updates:
FRUSDR -cfg master.cfg
The utility loads the specified CFG file and uses the information in that
file to:
•
Verify that the CFG file is the correct one for the hardware model
•
Load the data from the FRU files, prompting the user for
information as necessary
•
Select the proper SDRs and load them into nonvolatile storage
Using a specified FRU file
If you run FRUSDR using the master.cfg file, and FRUSDR halts
prematurely, you can update individual FRU areas by using the -fru
switch and a specific FRU file.
Note:
FRUSDR, when run using the -fru switch, does not check to
make sure it is running on the correct hardware for the specified
FRU file. The -fru switch causes FRUSDR to overwrite all
information in the specified FRU area.
Updating nonvolatile storage areas
The .fru and .sdr files are specific to a particular server platform. The
files include header information to identify the platform. The utility
verifies that a file is being used with the correct server before updating
any information in nonvolatile storage. Prior to updating the SDR
information, the SDR area in nonvolatile storage is cleared.
AA G900 ug - EN.book Page 187 Wednesday, September 25, 2002 5:23 PM
Summary of Contents for Altos G900
