AccuWeb EVO 150, Instruction Manual

Page: 29 / 137

EVO 150 Controller 27
LED Indicator Mode
3 5 0 The front-panel switchpad LEDs and edge detector null indicator LEDs
are enabled.
In this mode one or both null LEDs may be operational depending on
which edge detector is selected by the switchpad or PLC I/O inputs.
If Edge A is selected, then edge detector A’s null LED indicates the
position of web edge A and detector B’s null LED is off.
If Edge B is selected, then edge detector B’s null LED indicates the
position of web edge B and detector A’s null LED is off.
If Edge A and Edge B are both selected (Centerline mode), then edge
A’s null LED and edge B’s null LED operate in tandem and indicate the
position of the web’s centerline.
This is the default setting.
3 5 1 The switchpad LEDs and edge detector null indicator LEDs are enabled.
In this mode each edge detector null LED indicates the position of the
web sensed by that detector alone, and both null LEDs are always
operational.
3 5 2
The switchpad LEDs are enabled and the edge detector null indicator
LEDs are always off.
Use this setting if the web is photosensitive.
3 5 3 The switchpad LEDs and edge detector null indicator LEDs are always
off.
Use this setting if the web is photosensitive.
Sensor A Gap
3 6 0 Sensor A has a 1.5 inch gap.
3 6 1 Sensor A has a 4.0 inch gap. This is the default setting.
3 6 2 Sensor A has an 8.0 inch gap.
Note: This value is set by the Setting Screen Edge Detector Settings button.
Sensor B Gap
3 7 0 Sensor B has a 1.5 inch gap.
3 7 1 Sensor B has a 4.0 inch gap. This is the default setting.
3 7 2 Sensor B has an 8.0 inch gap.
Note: This value is set by the Setting Screen Edge Detector Settings button.