AccuWeb EVO 150, Instruction Manual, Page: 23 / 137

EVO 150 Controller 21
Parameters
The Parameters screen allows access to all controller parameters. The parameters screen can be
accessed via the gear icon on the Main screen. When the gear icon is pressed, the Parameter
screen appears. The parameters may be examined or changed by using the parameter entry
buttons located on the parameters screen.
The Parameter up-down arrows can be used to scroll through the parameters. The Value up-
down arrows can be used to scroll through each parameter’s respective range of values.
The Enter button is use to accept the change. To leave the data value at its original value press
Exit button.
Note: The Enter button must be pressed in order for a change in a parameter’s value to be saved
in the controller.
The parameters are described below:
Software Version
1 x x. x x This parameter displays the software version.
End-of-Travel Mode
2 0
No feedback.
This mode is used when the system has no motor drive
output.
2 1
Actuators with potentiometer feedback (MT, SF, and HF).
These
actuators use a potentiometer to sense actuator position and have
adjustable end-of-travel and servo-center limits.
Caution: To prevent jamming of the actuator make sure the end-of-travel
limits are set correctly. Refer to page 84 for more information about
setting end-of-travel limits.