AccuWeb EVO 150, Instruction Manual

Page: 50 / 137

EVO 150 Controller 48
Field installation of PLC I/O board:
1. Check header P2 on the controller board - straighten any bent pins.
2. Align the socket on the underside of the PLC I/O board with header P2 on the controller
board.
3. Push the PLC I/O board firmly onto header P2.
4. Secure the PLC I/O board to the standoffs with four #4-40, 1/4 inch long machine screws and
four #4 internal tooth star washers.
PLC wiring:
•
Refer to the connection diagrams on page 121 for PLC wiring information.
Operation:
Note: Refer to page 21 for more information about setting controller parameters.
•
The control inputs are either
maintained
or
momentary
, depending on the setting of
parameter 27.
In the
maintained
mode, deactivating all inputs will cause the actuator to stop.
In the
momentary
mode, deactivating all inputs will cause the system to remain in the last
valid operating mode. If the system is in Manual mode, deactivating all inputs will cause
the actuator to stop. The IN and OUT inputs must be
maintained
in order to move the
actuator.
•
The function of the AUXILIARY, EDGE A, EDGE B, and LINE / CENTERLINE inputs
depends on the setting of parameter 51 and 52.
•
The INHIBIT input overrides all PLC I/O inputs. To allow the PLC I/O inputs to operate
properly, the INHIBIT input must be inactive.