Abit SE6, User Manual

Page: 48 / 148

3-18 Chapter3
SE6
First Boot Device:
When the computer boots up, the BIOS attempts to load the operating system from the
devices in the sequence selected in these items: floppy disk drive A, LS/ZIP devices, hard
drive C, SCSI hard disk drive or CD-ROM. There are eleven options for the boot sequence
that you can choose (The default setting is
Floppy .):
Floppy ) LS120 ) HDD-0 ) SCSI ) CDROM ) HDD-1 ) HDD-2 ) HDD-3 )
ZIP100 ) LAN ) Disabled.
Second Boot Device:
Description is the same as the First Boot Device, the default setting is HDD-0 .
Third Boot Device:
Description is same as the First Boot Device, the default setting is LS/ZIP
Boot Other Device:
Two options are available: Enabled or Disabled. The default setting is Enabled . This setting
allows the BIOS to try three kinds of boot devices that are set from the above three items.
Swap Floppy Drive:
This item can be set as Enabled or Disabled. The default setting is Disabled. When this
feature is enabled, you don’t need to open the computer case to swap the position of floppy
disk drive connectors. Drive A can be set as drive B and drive B can be set as drive A.
Boot Up Floppy Seek:
When the computer boots up, the BIOS detects if the system has an FDD or not. When this
item is enabled, if the BIOS detects no floppy drive, it will display a floppy disk drive error
message. If this item is disabled, the BIOS will skip this test. The default setting is
Disabled .
Boot Up NumLock Status:
➤
On: At boot up, the Numeric Keypad is in numeric mode. (Default Settings)
➤
Off: At boot up, the Numeric Keypad is in cursor control mode.