10-9
Questions? Refer to Page 10-10 for Technical Support Instructions.
When a Control Test is Selected:
When a Linearity Test is Selected:
A control solution lot number has been
entered for a different level of control test
from the one that the monitor expected to
run (in the usual low-to-high sequence).
The user may choose to enter a different lot
number (usually, for the expected level) or
to run the level of test that matches the lot
number entered.
Press
1
to
ReEnter
the lot.
Or,
Press
2
to run the level of test that
matches the lot number already entered.
A new linearity kit lot number has been
entered, different from the linearity panel
currently stored in the monitor. Only one
panel of data is stored. The kit lot number
may have been entered incorrectly, or the
user may choose to replace the earlier data.
Press
1
to
ReEnter
a different linearity kit
lot number (typically, the number of the
previous kit).
Or,
Press
2
to proceed and
Replace Panel
,
using the new kit lot number. The existing
linearity data will be replaced by data
from the new lot.
There are no stored test results for the type
of data requested
Press
1
to
Exit
and return to the
Data Review Menu.
The monitor is not able to recall a previous
test result. This test result may not have been
uploaded from the monitor.
Press
1
to view the
Previous
result.
Or,
Press
2
to view the
Next
result.
Symptom/Error Message
Explanation
How To Respond
When Data Review is Selected:
Chapter 10: Troubleshooting