Parameterization
106 FEX300,
FEX500
OI/FEX300/FEX500-EN
Menu / Parameter
Value range
Description
Input/Output / Logic Setup /
DO1 Alarm Config
General Alarm
On / Off
Min. Flowrate Alarm
On / Off
Max. Flowrate Alarm
On / Off
Empty Pipe
On / Off
TFE
On / Off
Gas Bubble
1)
On / Off
Conductivity
1)
On / Off
Coating
1)
On / Off
Sensor Temp
1)
On / Off
Each alarm can be activated separately. This allows to
configure individually when the digital output DO1
signals an alarm.
Input/Output / Logic Setup /
DO2 Alarm Config
-
-
Refer to the description "DO1 Alarm Config".
Input/Output /
Pulse Setup
Pulse Mode
Pulses per Unit,
Frequenzmode
The menu is displayed only if under "Input/Output /
Digital Out Mode / DO1/DO2 Function" a Pulse ...
function is selected.
Select the operating mode for the digital output.
There are two operating modes available:
• „Pulses per Unit“: In pulse mode, pulses per unit
are output (e.g., 1 pulse per m
3
).
• „Fullscale Frequency“: In frequency mode, a
frequency proportional to the flowrate is output.
The maximum frequency corresponding to the flow
range end value is configurable (max. 5 kHz).
Default setting: „Pulses per Unit“
Pulses per Unit
1 ... 5250/s
Set the pulses per unit in the Pulses per Unit
operating mode.
Pulse Width
0.1 ... 2000 ms
Set the pulse width in the Pulse Mode operating
mode. The pulse factor and pulse width are
interdependent and are calculated dynamically.
Limit Frequency
Display only
Display of the limiting frequency for the pulse output.
Fullscale Frequency
0 ... 5000 Hz
Set the frequency for the flow range end value in
Fullscale Frequency operating mode.
italics
= Parameter can only be viewed at the "Advanced" password level.
1) Parameter / menu only available for FEP500 / FEH500.
Summary of Contents for FEX300
Page 169: ...Appendix OI FEX300 FEX500 EN FEX300 FEX500 169...
Page 170: ...Appendix 170 FEX300 FEX500 OI FEX300 FEX500 EN...
Page 175: ......
