ABB ACS880-14, Hardware Manual

Page: 27 / 248

See chapter/section Task
Installing the mechanical accessories into a enclos-
ure (page 141)
Drive modules with optional cabling panels (+H381)
•Install the cabling panels into the enclosure.
•Install the additional components into the enclosure:
for example, main disconnector, main contactor, main
AC, fuses, etc.
•If the main disconnector is installed into the enclos-
ure, connect the input power cabling to it
•Connect the input power cables and motor cables to
the cabling panel terminals.
•Connect the brake resistor and DC connection cables
(if any) to the cabling panel terminals.
•Install the drive module into the enclosure
•Attach the cabling panel busbars to the drive module
busbars.
•Connect the cables from the drive module to the
control unit and install the control unit into the enclos-
ure
Connecting the power cables (page 143)
Installing the drive module into the enclosure (page 146)
Connecting the external control unit to the drive mod-
ule (page 107)
Attaching the external control unit (page 109)
Manuals for any optional equipment
Mechanical installation (page 65)
Drive modules without full-size output cable connection
terminals (0H371) and IP20 shrouds (option
+0B051)
Electrical installation (page 99)
Manuals for any optional equipment
•Install the additional components into the cabinet: for
example, main PE busbar, main disconnector, main
contactor, main AC, fuses, etc.
•Install the drive module into the cabinet.
•Connect the power cabling between the drive module
and the rest of the main circuit components in the
cabinet (if any)
•Connect the input power cables and motor cables to
the drive cabinet.
•Connect the brake resistor and DC connection cables
(if any) to the drive cabinet.
•Connect the cables from the drive module to the
control unit and install the control unit into the cabinet.
Connecting the external control unit to the drive mod-
ule (page 107)
Connect the control cables to the drive control unit.
Installation checklist (page 151)
Examine the installation.
Start-up (page 153)
Commission the drive.
Appropriate firmware manual Operate the drive: start, stop, speed control etc.
Terms and abbreviations
Description Term
Gate driver board BGDR
Common mode filtering CMF
Distributed drives communication system protocol DDCS
Frequency converter for controlling AC motors Drive
Direct torque control, a motor control method DTC
Electromagnetic compatibility EMC
Optional analog I/O extension module FAIO-01
Introduction to the manual 27