ABB ACS880-14, Hardware Manual

Page: 153 / 248

Start-up
Contents of this chapter
This chapter describes the start-up procedure of the drive.
Start-up procedure
1. Only qualified electrical professionals are allowed to start-up the drive.
2. Make sure that the installation of the drive module has been checked according to the
checklist in chapter Installation checklist , and that the motor and driven equipment are
ready for start.
3. Perform the start-up tasks instructed by the cabinet-installer of the drive module.
4. Switch the power on, setup the drive control program, and perform the first start of the
drive and motor. See Quick start-up guide for ACS880 drives with primary control program
( 3AUA0000098062 [English]) or ACS880 primary control program firmware manual
( 3AUA0000085967 [English]). If you need more information on the use of the control
panel, see ACx-AP-x Assistant control panels user's manual ( 3AUA0000085685
[English]).
• For drives with ABB d u /d t filter: Check that bit 13 of parameter 95.20 HW options
word 1 is switched on.
• For drives with ABB sine filter: Check that parameter 95.15 Special HW settings is
set to ABB sine filter. For other sine filters: See Sine filter hardware manual
( 3AXD50000016814 [English]).
5. For drives with ABB motors in explosive atmospheres: See also ACS880 drives with
ABB motors in explosive atmospheres ( 3AXD50000019585 [English]).
13
Start-up 153
12