3Com REMOTE ACCESS SYSTEM 1500, Management Manual

Page: 63 / 300

Configuring the RAS 1500
61
Configuring the
RAS 1500
To configure the RAS 1500 for Telnet network dial-out service, follow
these steps. Each of these steps is detailed in this section.
■
Step One: Add a System Name
■
Step Two: Add an IP Network
■
Step Three: Add a Modem Group (optional)
■
Step Four: Add the Dial-out Service
■
Step Five: Add Users
■
Step Six: Save Your Work
Notes about the procedures
The commands below are performed in the RAS 1500 command line
interface (CLI). If you need assistance with accessing the CLI, refer to the
Getting Started Guide .
You must press Enter to issue a command in the CLI. This step is not
included in the procedures below.
Step One: Add a
System Name
The system name helps you identify the RAS 1500 during subsequent
configuration. Use the following command to add a system name:
set system name <name>
Example:
set system name ras1500_lab
Table 6 RAS 1500 System Parameters
Parameter Description
system name
Designation of the RAS 1500. This parameter cannot
include spaces, and its maximum length is 64 characters.