3Com REMOTE ACCESS SYSTEM 1500, Management Manual

Page: 27 / 300

Configuration with the CLI
25
Configuration with
the CLI
This section describes how to set up your RAS 1500 with the full CLI. To
configure the RAS 1500 with CLI Quick Setup, see “Using CLI Quick
Setup”.
Step One: Power On
the RAS 1500
To begin manual configuration, power on your RAS 1500. After a few
moments when your screen has registered system initialization. The
RAS 1500>
prompt appears. When prompted by the Quick Setup
Program to continue, enter the following:
no
Step Two: Configure
the RAS 1500 Basics
Use the following steps to configure a basic setup on the RAS 1500:
1 Name your RAS 1500 and specify additional system information. The
name you enter serves as the RAS 1500 DNS name and SNMP system
name. The name is also the name that the RAS 1500 advertises in SAP
broadcasts.
The name must be unique; no other device on your network can share it.
a Set system information. Use the following command:
set system name <“RAS 1500 name” (up to 64 characters)>
location [“system site”]
contact [“contact information”]
You can enter the command all at once or in separate commands.
Example:
set system name superstack location boston contact “Bob
@508 555-4567 666x”
Or, you can enter the following:
set system name superstack
set system location boston
set system contact “Bob @ 508 555-4567 666x”
b Set the system date and time. Use the following command:
set date <dd-mon-yyyy> time <hh:mm:ss>
Example:
set date 01-jan-2001 time 01:01:01