3Com REMOTE ACCESS SYSTEM 1500, Management Manual

Page: 170 / 300

168 C
HAPTER
11: C
ONFIGURING THE
RAS 1500
ROUTER
For example, at the host prompt, use the following command:
C ] send AYT
You can use the
set_escape
command to change the Telnet escape
character to a character of your choice. Use a carat (
^
) to precede
another character.
Example:
set_escape ^X
Closing a Connection
The
close
command shuts down an active Telnet connection.
Troubleshooting
Commands
Viewing Facility
Errors
The
set facility
command allows you to set and view log levels for
the system processes, ensuring that error messages reaching the
threshold for that facility will be output to the console port.
Although messages are sent to the Console port by default, you can
configure a SYSLOG host to receive messages. This would free up the
Console since sending messages uses system resources and can slow
down the connection.
Log levels range from the lowest state, debug, to the highest, critical. The
default is critical. Use the following command:
set facility <name>
loglevel [common | critical | debug | unusual | verbose]
Example:
set facility snmp loglevel unusual
Use the
list facilities
command to view a log level change.
Terminating an Active
Process
The
kill
command terminates an ongoing process. You can kill a
process only after it has started. For instance, if you want to kill a
ping
request that has run too long. Use the
list processes
command to
view current active processes.