3Com CoreBuilder 9000, User Manual

Page: 195 / 468

Signaling Setup 195
Update
Call-Proceeding
Enable Value
Update the signaling call-proceeding enable flag and save it to flash
memory. See the previous section for more details.
Command Actions
Command Result
Example
Enter:
1 1 4 6 2 1
The following message appears:
Call proceeding flag was successfully set to ON.
The call-proceeding enable flag is updated to on and saved to flash.
Enter the menu sequence:
(1) SYS: Platform configuration
(1) SET: Switch setup
(4) SIG: Signaling setup
(6) CCL: Signaling call control
setup
(2) SET: Set call proceeding value
Enter a parameter at the prompt
Parameter Format or Range
Call-proceeding message
enable/disable value
0
to suppress call-proceeding messages (off)
1
to send call-proceeding messages (on)
Direct access sequence:
1 1 4 6 2
[parameters]
System action taken: The call-proceeding enable flag is updated.
System message display:
Call proceeding flag was successfully
set to: <ON/OFF>