3Com 4007, Implementation Manual, Page: 81 / 684

Configuring the Terminal 81
Configuring the
Terminal
This section describes:
■
Configuring the Terminal to Default Settings
■
Changing the Terminal Configuration
■
Customizing Terminal Settings
Configuring the
Terminal to Default
Settings
Configure the terminal that is attached to the serial port on the EME to
the same parameter settings as the EME. In doing this, you allow the
terminal and EME to communicate. Initially, the terminal settings must
match the factory-default settings of the EME, as specified in Table 21. To
display the current terminal settings, use the
show terminal
command.
To access the Administration Console, use the
connect <slot>.1
command.
To configure the terminal:
1 Consult the user guide that was shipped with your terminal for
instructions about setting the terminal values.
2 After you configure your terminal to match the factory defaults of the
EME, press Enter.
The following message appears:
CoreBuilder 9000 Enterprise Management Engine (vx.xx)
Copyright (c) 1999 3Com Corporation
3 At the
Login
prompt, enter a login name.
The default login name is
admin
The EME prompts you for a password. By default, there is no password.
Table 21 Terminal Defaults and EME Options
Parameter
(SET TE) EME Options (when connected) Factory
Default
Baud 300, 1200, 2400, 4800, 9600, 19200, 38400 9600
Data_bits 7 or 8 8
Parity odd, even, or none none
Stop_bits 1 or 2 1
Hang_up enable or disable disable
Mode command line or slip command line
Terminal_type VT100