3Com 4007, Implementation Manual, Page: 516 / 684

516 C
HAPTER
20: IPX R
OUTING
Key Guidelines for
Implementation
Consider the guidelines in this section when you configure your
Multilayer Switching Module for IPX routing.
Procedural Guidelines Complete the following steps to set up IPX routing on your Multilayer
Switching Module:
1 Set up your VLAN interfaces.
2 Define the IPX interfaces before you define the routes and servers.
3 Define routes.
4 Define servers.
5 Select RIP or SAP, if you plan to use them.
6 Define IPX forwarding.
See the Command Reference Guide for commands that you use for these
steps.
General Guidelines Consider the following general guidelines before you configure IPX
routing on your Multilayer Switching Module:
■
Every IPX interface has one IPX VLAN and other associated
information.
■
The IPX router has one IPX interface defined for each network to
which it is directly connected.
■
Before you define an associated IPX interface for a network, you must
first define a VLAN. See Chapter 14.
■
The IPX router has one IPX interface defined for each network to
which it is directly connected.