2N® LiftIP 2.0 User Manual
29
/
119
•
•
•
•
Volume Control
Press the VOL
−
/VOL+ button shortly to turn down/up the speaker volume by one level. The
master volume low/high limit is confirmed by an acoustic signal.
ALARM 1/2 Default Setting
Press the AUTODETECT button for approx. 10 s to detect the ALARM 1/2 input control type. The
detected values are automatically written into the software configuration. The input control
type is considered as the relax state at the moment of auto detection. Resetting of the input
default values is indicated by an acoustic signal.
Device Restart
Press the RESET button for approx. 10 s to restart the device without any configuration change.
IP Address, IP Address Change and Factory Reset
The VOL
−
/RESET/CONFIG button located in the left-hand upper part of the main unit helps you
retrieve the device IP address, switch the IP address static/dynamic states and reset the device
factory defaults.
Current IP address retrieval
Follow the instructions below to
retrieve the current IP address
:
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal
can be heard (approx. 30 s).
Release the RESET button.
The device announces the current IP address via the speaker automatically.
•
Note
The time interval between the RESET long press and device reconnection to the
network after restart is a few tens of seconds.
