Zonex ZonexCommander, Руководство по установке

Страница: 9 / 54

9
3. When the installation calls for an on-site, direct connected computer,
the Command Center must be located within 10’ of the computer if the
4. Install a 24vac 40va dedicated transformer for each individual
Command Center, and wire to terminals “G” and “B.” ( See Fig. 1)
6. A single air sensor ( OLAT ) is supplied to display the Outside Air
Temperature on the System screen of the Commander program. It
7. The twisted pair communication wire (Belden 8740) is to be daisy
chained to each communicating device, which is controlled by the
specific Command Center. When multiple Command Centers are used,
each Command Center is to have a dedicated communication loop.
The communication loop is polarity sensitive on RX and TX.
Wire
nuts are never to be used on the communication wire. When
splicing wire, use screw type terminal strips or solder.
NOTE: for systems with potential electrical interference, such as
large transformers, VFDs, etc, shielded twisted pair (Belden 8450)
may be used for the communications loop.
ZONEXCOMMANDER INSTALLATION INSTRUCTIONS
Fig.1
1. Install the CETCIP Command Center on a wall or mounting board
in a dry interior space where the ambient temperatures will be between
32° and 125° non-condensing.
2. When installing multiple Command Centers, mount all boards
together on the same surface.
NOTE: 120vac outlets are required for the TCIP iServer device power
supplies.
5. For system TCIP configuration, you must provide a 120vac outlet for
CETCIP Command Center
the power supply.
which is field provided.
USB cable is used. The TCIP device requires an Ethernet cable,
NOTE: Power supply voltage on G and B should be 24 to 28vac.
leads must be extended, simply use standard 18/2 thermostat wire,
and connect to the S S terminals on the Command Center.
should be installed where it will not be in direct sunlight. If the sensor