KLIC-LG1
http://www.zennio.com
Technical Support:
http://support.zennio.com
6
Important
:
If intending to control the A/C unit both through its incorporated wired remote
control and through KLIC-LG1, it must be taken into account that orders sent
from the wired remote control will have a higher priority than those sent
through KLIC-LG1.
If there are several indoor units connected to a single outdoor unit, all of
them must work in the same mode (heating or cooling). If they work in
opposite modes, the CH 07 error will appear.
For detailed information about the technical features of KLIC-LG1, as well as on security
and installation procedures, please refer to the device
Datasheet
, bundled in the device
packaging and also available at
http://www.zennio.com
.
1.3
START-UP AND POWER LOSS
Depending on the configuration, some specific actions will be performed during the
device start-up. The integrator may set up an initial status to be sent to the A/C unit after
the bus power recovery, and whether certain objects should be sent to the bus after the
power recovery, as described in later sections.
On the other hand, when a bus power failure takes place, the device will interrupt any
pending actions, and will save its state so it can be recovered once the power supply is
restored.
Notes
:
After a bus power failure, it can take up to a minute to establish the connection
between KLIC-LG1 and the A/C unit.
The configuration of the remote wired control will be sent if this control is
plugged after KLIC-LG1
.
