KLIC-LG1
http://www.zennio.com
Technical Support:
http://support.zennio.com
5
1.2
INSTALLATION
Figure 1. Element scheme.
KLIC-LG1 connects to the KNX bus via the corresponding built-in terminal (5). Once the
device is provided with power from the KNX bus, both the physical address and the KLIC-
LG1 application program can be downloaded.
This device does not need any external power as it is entirely powered through the KNX
bus.
The remaining elements are described next.
Prog./Test button (2)
: a short press on this button will set the device into the
programming mode, making the associated LED (1) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. The LED will blink in red every 0.5 seconds
Analogue-Digital Inputs (3)
: input ports for the stripped cables of external
elements such as switches, motion detectors, temperature probes, etc.
Terminal connection, RYB (4)
: wires that will connect KLIC-LG1 to the A/C
unit. The other end of the cable, therefore, is intended to be connected to the
corresponding connectors in the PCB board of the internal unit.
Figure 2. Connecting KLIC-LG1 to the A/C unit.
1. Prog./Test LED indicator
2. Prog./Test button
3. Analogue/digital inputs
4. Terminal connection RYB.
5. KNX connector
