KLIC-LG1
http://www.zennio.com
Technical Support:
http://support.zennio.com
20
the A/C unit or reading the current status This object will be typically linked to
a window sensor or a similar event trigger.
Automatic Off Object Polarity
: sets the polarity of the above
object: “0
= Activate; 1 = Deactivate On
” or “0 = Deactivate; 1 = Activate”.
Automatic Off Delay
: sets the time, in seconds, KLIC-LG1 waits before
switching the A/C machine off. Any switch-off order received during the
delay will abort the time count. This delay can be modified at runtime
through the object
“[AC] Automatic Off Delay”
. The sending of the value
“0” disables the automatic off functionality.
Note
:
switch-on orders sent to the A/C unit from a wired remote control have
a higher priority than the Auto Off mode.
INITIAL CONFIGURATION
Figure 13: A/C Gateway. Configuration. Initial Configuration.
Initial Configuration
:
allows setting the desired initial state that KLIC-LG1 will
send the A/C unit after programming or restarting the device:
“Default”: the initial state will be the last one KLIC-LG1 is aware of.
“Custom”: see section 2.4.4.
SCENES
Figure 14: A/C Gateway. Configuration. Scenes.
Scenes
:
allows setting up different scenes (up to 5), consisting each of them
in a set of orders to be sent to the A/C unit upon the reception of scene trigger
values through the KNX bus. See section 2.4.5.
