Zaxcom Fusion User’s Manual_____________________________________________________Chapter 11
161
4.
Perform the following to install the new firmware:
a.
Go to the
Main Menu page
{
p.35
}.
b.
Enter
036
using the numeric keys.
c.
Go to the
Setup page
{
p.53
}.
d.
Press the
Service
button
(the
Fusion Service Menu page
{
p.127
} is displayed)
e.
Depending on what media you are using to install the software (basically whether or not its format is
recognized), perform one of the following:
i.
If the format is unrecognized (CD-R or DVD-R), press the
Load From CD-R
button
ii.
If the format is recognized (hard disk drive, SD media or DVD-RAM), press the
Load Progfile
button
f.
The
Debug Screen page
{
p.128
} is displayed and the following appears on it. The process takes about 5
seconds:
Starting ReadDevaProgramFile
opened Deva prog file
imported 5MB at 2545kB/sec Version String:
DateTimeVer:mmm dd yyyy
hh:mm:ss
v7.09
Calculating Checksum…size=0x00500000 Vs: <7><9>
DevaProgFile.bln is now in temporary memory
The last line indicates that the firmware was successfully installed in temporary memory.
g.
Press the
Burn Program ROM
button
h.
The
Debug Screen
page
is cleared and the following appears on it. The process takes a little over three
minutes:
... BurnBigROM() ...
Erasing 81 ROM sectors (5308kB)
..........................
Writing Deva Program to ROM
..............................................
ReadBackTest:Checking BootROM...
BURN-ROM task finished **TURN POWER OFF NOW**
IMPORTANT:
Do not power down the Fusion until the page indicates that you can.
i.
Cycle the power to run on the newly installed firmware.
(You have successfully completed the installation … HAVE FUN with the new version!!!)