York YDAJ87HU7, Руководство пользователя, Страница: 15 / 100

FORM 150.75-NM2
15
YORK INTERNATIONAL
The pins will lock when pushed into the connector. Take
care to assure the pins are placed into the correct sock-
ets in the connector. The connector may then be plugged
into J17 on the Micro Board as shown above.
The sensor, cable, and connector are included in the
Splicing Kit.
“MIXED WATER TEMP”, “SYS 1 & 2 PRESSURES”
AND “SYS 3 & 4 PRESSURES” LABEL INSTALLATION
A MIXED WATER TEMP adhesive label MUST be in-
stalled on the keypad of the Control Panel. Carefully
install the label in the position shown in Fig. 11. This
label is included as part of the Splicing Kit.
“SYS 1 & 2 PRESSURES” and “SYS 3 & 4 PRES-
SURES” labels must be installed to indicate dual pur-
pose keys. “SYS 1 & 2 PRESSURES” label should be
applied over the “SYS 1 PRESSURES” label and “SYS
3 & 4 PRESSURES” should be applied over the “SYS 2
PRESSURES” label.
COMPRESSOR MOUNTING
The compressors are mounted on four (4) isolator pads
(one under each compressor foot). (See Fig. 12.) The
mounting bolts are not to be loosened or adjusted at
installation.
COMPRESSOR INSULATION
In high humidity environments, compressor sweating
may be noted. In most applications, this is of no con-
cern. However, if it is undesirable, it is the responsibility
LD01918
FIG. 9 – MIXED WATER TEMP WIRING
FIG. 10 – MIXED WATER TEMP SENSOR
CONNECTOR INSTALLATION
LD01919
FIG. 11 – MIXED WATER TEMP LABEL LOCATION
LD01920
25112A
COMPRESSOR MOUNTING PAD