IM 701240-02E
Recording X-Y (Amplitude-Amplitude) Waveforms
Recording X-Y (Amplitude-Amplitude) Waveforms
Recording X-Y (Amplitude-Amplitude) Waveforms
Three recorder modes are available on the SL1400: Memory, Chart Recorder, and X-Y Recorder. This section explains the
procedure to display and record in X-Y Recorder mode.
For operations in Memory mode, see page 16. For operations in Chart Recorder mode, see page 26.
Carry out the following work before continuing with the subsequent procedure.
1. Load the roll paper according to the procedure given in section 3.5, "Loading the Roll Paper
for the Built-in Printer" in the user's manual.
2. To display and record the X-Y waveform, apply two waveform signals (repetitive sine waves
with an amplitude of approximately 5 V and frequency of approximately 1 Hz and 4 Hz) to
the input terminal of CH1 and CH2. For the procedure to connect the probe to the input ter-
minal, see "Connecting Probes" on page 15 in this operation guide.
Setting the Recorder Mode to X-Y Recorder
Section 9.1, "Selecting the Recorder Mode" in the user's manual
2
Press
MODE
.
3
Press the
X-Y Recorder
soft key.
1
Press
START/STOP
to stop the waveform acquisition.
Waveform acquisition is stopped when the RECORD
indicator above the key is OFF.
RECORD
START/
STOP
MODE
The recorder mode is set to X-Y Recorder.
The waveform can be displayed on the screen and recorded on the
built-in printer.
The waveform display on the screen starts simultaneously with the start of the
waveform acquisition. Unlike the T-Y waveform recording, the recording on the
built-in printer starts when the acquisition is stopped (ON/OFF selectable).
