IM 701240-02E
Preparation
Turn ON the Power Switch
Section 3.4, "Connecting the Power Supply and Turning ON/OFF the Power Switch" in the user's manual
Press the power switch located on the left side panel to the "ON (|)" side.
Power switch
Connecting Probes
Section 3.7, "Connecting Probes" in the user's manual
Section 3.8, "Compensating the Probe (Phase Correction)" in the user's manual
To use the SL1400 safely, read the warnings given in section 3.7, “Connecting Probes” and the
cautions given in section 3.8, “Compensating the Probe (Phase Correction)” in the user’s manual
before connecting the probe.
Connect the probe to the input terminal (CH1) of the SL1400.
Connect the probe tip to the probe compensation signal output terminal on the SL1400 front panel.
Connect the earth wire to the functional earth terminal.
Functional ground
terminal
Input terminal
Probe compensation signal output terminal
Note
When actually observing waveforms, make sure to perform phase correction (section 3.8) and calibration (section 4.6) of the probe
according to the instructions in the user’s manual. Otherwise, waveforms cannot be observed correctly.
