IM 701240-02E
Recording T-Y (Time-Amplitude) Waveforms
Recording T-Y (Time-Amplitude) Waveforms
Recording T-Y (Time-Amplitude) Waveforms
Three recorder modes are available on the SL1400: Memory, Chart Recorder, and X-Y Recorder. This section explains the
procedure to display and record in Chart Recorder mode.
For operations in Memory mode, see page 16. For operations in X-Y Recorder mode, see page 31.
Carry out the following work before continuing with the subsequent procedure.
1. Load the roll paper according to the procedure given in section 3.5, "Loading the Roll Paper
for the Built-in Printer" in the user's manual.
2. To display and record the T-Y waveform, apply a repetitive sine wave with an amplitude of
approximately 5 V and frequency of approximately 1 Hz to the input terminal of CH1. For the
procedure to connect the probe to the input terminal, see "Connecting Probes" on page 15
in this operation guide.
Setting the Recorder Mode to Chart Recorder
Section 9.1, "Selecting the Recorder Mode" in the user's manual
2
Press
MODE
.
3
Press the
Chart Recorder
soft key.
1
Press
START/STOP
to stop the waveform acquisition.
Waveform acquisition is stopped when the RECORD
indicator above the key is OFF.
RECORD
START/
STOP
MODE
Recorder mode is set to Chart Recorder.
The waveform can be recorded on the built-in printer (ON/OFF
selectable) simultaneously with the waveform display on the screen.
Setting the Record Conditions
Initializing Settings
Section 4.4, "Initializing Settings" in the user's manual
The settings entered using the front panel keys are reset to factory default.
This operation is not necessary if you are using the SL1400 for the first time after purchase. However, please execute the
operation for your learning. This initialization operation is useful when you wish to redo the settings from scratch according to
the input signal.
1
Press
MENU
.
2
Press the
Next 1/2
soft key.
3
Press the
INITIALIZE/CAL
soft
key.
MENU
