Yamatake SDC35, Руководство пользователя

Страница: 91 / 280

5-33
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
■
SP setup in operation display mode
The set value for LSP in use of LSP1 to 8 can be set.
The LSP set value is different from the SP display value during SP ramp.
However, the set value is displayed while the key is being operated to change the
setting.
• When [bit 1: SP display] of [C74: PV/SP display setup] is set at "1" (display is
provided), the display and setting can be made.
• The SP cannot be set in the RSP mode.
■
LSP system group
The LSP system group can be selected.
■
SP ramp type
Either the standard ramp or multi-ramp can be selected.
Additionally, for details about step operation, refer to;
5-6, Step operation (on page 5-41)
.
• When this setting is set at “0”, the ramp-up and ramp-down use only one setting
group (SP ramp-up and SP ramp-down of parameter bank) even though one LSP
group or multiple LSP groups are used.
• When this setting is set at “1”, the ramp setting (ramp 1 to 8 of SP bank)
common to the up/down to be set by LSP group is used.
■
RSP input type
The RSP input signal type can be selected.
• When the model provides the RSP input, the display and setting can be
performed.
Item (Bank) Display Contents Initial value User level
SP (Operation display) SP low limit to SP high limit U 0 U Basic,
Standard,
High function
Item (Bank) Display Contents Initial value User level
LSP system group
(Setup bank) 1 to 8 1 Basic,
Standard,
High function
PV is
shown on
the upper
display.
Item (Bank) Display Contents Initial value User level
SP ramp type
(Setup bank) 1: Multi-ramp
2: Step operation The step operation is
stopped when the power is turned ON
again (READY).
3: Step operation The step operation is
recovered when the power is turned ON
again.
0 High function
Item (Bank) Display Contents Initial value User level
RSP input type
(Setup bank) 0: 4 to 20mA
1: 0 to 20mA
2: 0 to 5V
3: 1 to 5V
4: 0 to 10V 0 Basic,
Standard,
High function