Yamaha CS1D, Руководство пользователя

Страница: 46 / 617

38
Checking the operation of an output unit
This section explains the procedure for checking the operation of an output unit connected to the DSP1D-EX {DSP1D}
engine. The general procedure is as follows.
Connect an input source to an input unit
m m m m
Connect your monitor system to an output unit
m m m m
Turn on the power in the order of input unit
→
DSP1D-EX {DSP1D} engine
→
CS1D console
→
monitor system
m m m m
Patch the input unit to an input channel
m m m m
Patch the output unit to the STEREO A channel
m m m m
Send the input channel signal to the STEREO bus
m m m m
Check whether the signal is output from the STEREO OUT A jacks
Preparations for checking
Before you begin checking the operation of an output unit, make sure that the following actions have been completed.
•
Connect the various components that are part of
the PM1D system (
→
p.6–13)
•
Use the indicators/LEDs of the input/output units
and the engine to verify that the components are
correctly connected to each other (
→
p.14–21)
•
Set the operation mode and the word clock master
as appropriate for the configuration of the PM1D
system that you are using (
→
p.22–29).