Xylem WTW Multi 3430, Руководство по эксплуатации

Страница: 100 / 134

Multi 3430
Operation
100
ba75865e19 04/2015
4.12.4 Calibration
The MPP 9x0 IDS multi parameter probe is calibration-free.
The IDS sensors of the XXX-P series have to be calibrated directly on
the meter (see section 4.12.5). Calibrating on the MPP 9x0 IDS multi
parameter probe is not possible.
4.12.5 What to do if ...
Display
Sensor input open!
Display
The parameter, depth of
immersion, is not
displayed
Calibrating, resetting,
updating IDS sensors
of the XXX-P series
Cause Remedy
– A plug-in position of the MPP
9x0 IDS multi parameter probe is
still open
– Connect a sensor
or
– Close the plug-in position
with a blind plug
– A blind plug is not recognized – Check the blind plug
– Unplug all sensors from
the meter.
– Connect the blind plug to
the meter with a cable. If
the blind plug is operable,
the following message is
displayed:
Blind plug is
connected
– Exchange a defective blind
plug if necessary
– Another IDS sensor is con-
nected to the meter in addition to
the 9x0 IDS multi parameter
probe
– Disconnect the additional
IDS sensor
– The firmware of the meter does
not support the sensor
– Carry out a firmware update
for the meter
(see section 9.1)
1 Disconnect the multi parameter probe from the meter.
2 Disconnect the IDS sensor of the XXX-P series from the multi
parameter probe.