Xylem OxiTop Control OC 100, Руководство по эксплуатации

Страница: 22 / 84

Operating mode: BOD Standard / BOD Routine OxiTop
®
Control OC 100
22
ba31114e07 08/2014
Confirm the selected measure-
ment range for the sample. The
automatically assigned sample
number (YY/MM/DD and
sequential number) is given in
the header line.
Additional information:

Type of measurement, run duration, measurement range,
final date, ID number.

Temp display => the AutoTemp function (see section 7.1
GLP/TOOLS
MAIN MENU
, page 41) is switched on.

GLP display => the GLP function (see section 7 GLP/
TOOLS, page 41) is switched on.
Change the ID number for the additional identification of the
sample (e.g. sampling location) as follows:

Select the - I.D. number menu item with <

><

>

Confirm with <RUN/ENTER> .

Set the required Id number (setting range 001 ... 255) with
<

><

> .

Confirm with <RUN/ENTER> .
Use <PRINT> to print out the entire sample information
(in BOD Routine mode only), see section 6 P
RINTING
, page
39).
Confirm the start of measure-
ment. Contact selection:
The controller repeatedly sends the start information in the
scanner mode until feedback is successfully received from the
OxiTop
®
measuring head. After the successful start message
from the measuring head:
Displays ! started !
From this
point in time, the sample exists
within the
SAMPLE STATUS
TYPE list ( sample manage-
ment).
Subsequently, the request to
start the next measuring head is
made automatically.
In BOD Routine operating mode there is no

1... identifier in
the display, and the
controller automatically returns to the entry menu after starting
the measuring head.
RUN/ENTER
RUN/ENTER