Xerox 460, Инструкция по установке и устранению неисправностей

Страница: 36 / 210

Page 3 - 8 Xerox Document Centre Network Installation & Troubleshooting Guide
9. Set the Subnet Mask and Gateway (skip steps 9a-9b if your
server supplies this information).
a) Press the Subnet and Gateway button.
b) One at a time press the soft buttons on the touch screen
for each octet of the Subnet Mask and enter the numbers
from the keypad. Repeat this process for the IP Gateway
address. When finished press
Save to record the changes
and exit to the TCP/IP Settings screen.
c) Press the Close button.
10. Enable lp and lpr printing (skip steps 10a-10b if you DO
NOT wish to print to your Document Centre using lp or lpr.
a) Press the TCP/IP - Line Printer button. At the next
screen press the Enable button.
NOTE: While you can change the port number at which your Document
Centre will accept lpr print jobs it is recommended that you do this
ONLY with extreme caution as most lpr spoolers are set to send
print jobs to the default port.
b) If you wish to change the lpr port for your printer press
the port soft button and enter the desired port number at
the keypad. Press
Save .
c) Press the Close button.
d) Press the Exit Tools button.
11. Wait a MINIMUM of 7 minutes for the printer to reset.
a) Review the Configuration Report page.
b) Obtain the Document Centre printer MAC address and
TCP/IP address information from the Configuration
Report page.
c) If your server does not dynamically update the
/etc/ethers and /etc/hosts files with a host name, you
will need to do this manually. Consult your server docu-
mentation for details.