Xerox 460, Инструкция по установке и устранению неисправностей

Страница: 16 / 210

Page 1 - 2 Xerox Document Centre Network Installation & Troubleshooting Guide
How to Use this Document
This document has been arranged to get the printer set up on your
network quickly and with minimum reading.
1. Before connecting network cabling to the Document Centre
device, perform the procedure contained in this document
entitled
How to Connect to Ethernet / Token Ring
Networks .
2. For Dynamic TCP/IP addressing use either the
DHCP/BOOTP Dynamic IP Address Assignment Quick
Install Card
or the RARP Dynamic IP Address
Assignment Quick Install Card .
3. Review the Table of Contents. Find the network operating
system (NOS) or protocol, which pertains to your network.
4. Go to the page indicated and perform the procedure(s).
5. Once you are finished it is recommended you print a test page.
6. Check the print job for print quality. If print quality problems
exist, use the
Problem Solving section of the Reference
Guide to correct the problem.
7. If your print job DID NOT print, see the Troubleshooting
section for your operating system in this document to correct
the problem.
8. Once your Document Centre is installed and printing, you can
repeat these steps to enable your printer to print with
additional protocols or network operating systems.
NOTE For detailed safety information about this product refer to the
Document Centre Reference Guide .