Page: 32
SmartPad LCD
¥
© 2006 Xantech Corporation
5. Click on the POWER command or other basic function command as listed in the IR Library. The
controlled component should respond to each command sent. (i.e. “Power” turns the source ON or
OFF, “PLAY” plays the content etc.)
6. If a component does not respond to a command, click on another Command Group listed under that
manufacturer and retest.
7. If the codes for the specified component are present, you are now ready to start creating Macro’s under
the GTL buttons you created in the previous section. Please see the Section entitled
Placing
Commands onto the GTL’s
. If no working commands can be found in the IR Library, please proceed
to the following section entitled
Learning IR Commands
.
Содержание CSPLCD39G
